Inflating The Boat - Sport Z-RAY III 500 Serie Manual De Instrucciones

numbers as well as safety advisories and rules (such as "No
jumping or Diving")
The total number of persons and total weight shall not exceed the
-
information printed on the boat. Do not exceed the maximum
recommended capacities. Overloading violates regulations.
INFLATING AND DEFLATING THE BOAT:
Inflating
If the boat is inflated during cold weather or without direct sunlight on
the tubes, care must be taken not to over-inflate the tubes. As the air
inside the tubes heats up due to temperature rises or sunshine, the
pressure will increase. The boat is not fitted with a safety valve, so the
pressure must be monitored at all times.
Select a clean area free of stones, gravel, sticks or other sharp
-
objects.
Carefully unfold the boat, spreading out the tubes and floor to
-
make them as smooth as possible. NOTE: For ease of install, it is
preferable to set up the boat on a warm and sunny day. If time
permits, expose the unrolled boat to direct sunlight for 1 hour or
more, so that the boat material will be more flexible during
installation.
CAUTION: DO NOT DRAG THE BOAT, AS IT MAY TEAR THE
BOAT OR CAUSE OTHER DAMAGE.
- Install the
Z-ray
Installation of seat bench
-
Insert the rods into the seat retaining tubes. Slide the seat into
position by inserting the retaining tubes into the grooves, located at
each end of seat bench. Insert into both ends of the seat at the
same time. Position the seat to be in the middle of the retaining
tubes.
All manuals and user guides at all-guides.com
III apart inflatable floor to the boat bottom first.
7