Ironside Prolaser ALL-LINES Manual Del Usuario página 21

4. Checking 90º accuracy between the 2 vertical beams.
This procedure requires a room of at least 5x5 meters with 4 walls.
1) Set up the laser on the table or on the floor in the middle of the room
2) Unlock the pendulum safety lock (#11), to project the forward
horizontal and vertical cross beams.
3) Press the H (#1) button to turn off the horizontal beam
4) Press the V (#2) button twice to project all 4 vertical
beams.
5) Project the forward vertical beam towards wall A.
(see figure #9).
# ‫תמונה‬
102381
A
D
Figure # 9
Figure # 9
B
C
21