Product specifications
Spécifications du produit
Especificaciones del producto
Produktspezifikationen
Specifiche del prodotto
产品规格
Speaker output power: (3.5W x 2) 7W RMS; 14W Peak
Drivers: 2.0 inch with dual passive bass woofers
Impedance: 4 Ohms
Input power: 5V ⎓ 1A
Frequency response: 120Hz – 20KHz
Signal-to-noise ratio: > 80dB
Input audio: 3.5mm audio plug
Dimensions: 5.8 x 4.4 x 2.7 inches (each speaker)
USB / Audio cable length: 5 feet
Speaker separation: up to 3 feet apart
Weight: 2.5 pounds
Puissance de sortie haut-parleur: (3,5W x 2) 7W RMS; Maximum 14 W
Drivers: 5.08 cm avec deux woofers de basses passifs
Impédance: 4 Ohms
Puissance d' e ntrée: 5V ⎓ 1A
Réponse en fréquence: 120Hz – 20KHz
Rapport signal sur bruit: > 80dB
Entrée audio: prise audio 3,5 mm
Dimensions: 14,73 x 11,17 x 11,17 cm (chaque haut-parleur)
Longueur du câble audio / USB: 152 cm
Séparation haut-parleur: jusqu'à 91,44 cm à part
Poids: 1,13 kg
FCC Compliance Notice
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy
and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
11