Fcc Compliance Statement; Safety Considerations; Installation Considerations - JL Audio MediaMaster 105 Manual Del Propietário

FCC COMPLIANCE STATEMENT

This device complies with Part 15 of
the FCC Rules. Operation is subject
to the following two conditions:
(1) this device may not cause harmful
interference, and (2) this device
must not accept any interference
received, including interference that
may cause undesired operation.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and
can radiate radio frequency energy
and, if not installed in accordance with
the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee
that interference will not occur in a
particular installation. If this equipment
does cause harmful interference to
radio or television reception, the user
is encouraged to try to correct the
interference by one or more of the
following measures:
- Reorient or relocate the
receiving antenna.
- Increase separation between the
equipment and the receiver.
- Connect the equipment to an outlet
on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced
radio/TV technician for help.
Any changes or modifications
not expressly approved by the
party responsible for compliance
could void the user's authority
to operate this equipment.

SAFETY CONSIDERATIONS

• Only use this product in vehicles with
12 volt, negative-ground electrical
systems. This product is not certified or
approved for use in aircraft.
• Mount this product securely to prevent
damage or injury in severe conditions.
• Do not replace the power wire fuse
with one of a different value.
Never bypass the fuse.
• Listen to your audio system at levels
appropriate for operating conditions
and hearing safety.

INSTALLATION CONSIDERATIONS

• Installation requires appropriate tools
and safety equipment. Professional
installation is recommended.
• This product is water-resistant.
Do not submerge or subject to
high-pressure water spray.
• Before installation, turn off the audio
system and disconnect the battery
system from the audio system.
• Install in a dry, well-ventilated
location that does not interfere with
your factory-installed systems. If a
dry environment is not available,
a location that is not exposed to
heavy splashing may be used.
• Before cutting or drilling,
check for potential obstacles
behind mounting surfaces.
• Carefully route all system wiring away
moving parts and sharp edges; secure
with cable ties or wire clamps and use
grommets and loom where appropriate
to protect from sharp edges.
2
x1 x1
x1 x1
3
x1
#8 x 1 in (25 mm)
(x4)