Fill The Rinse Aid Dispenser - Kunft KDW4752N Manual De Instrucciones

Only fill with salt just before starting one of the complete washing
programmes.
This will prevent any grains of salt or salty water, which may have
been split, remaining on the bottom of the machine for any period of
time, which may cause corrosion.
After the first washing programme the control panel light expires.
A. Remove the lower basket and then unscrew and remove the cap
from the salt container. 1
B. If you are filling the container for the first time, fill 2/3 of its volume
with water (around 500ml). 2
C. Place the end of the funnel (supplied) into the hole and introduce
about 2kg of salt. It is normal for a small amount of water to come
out of the salt container.
D. Carefully screw the cap back on.
E. Usually, the salt warning light will be off in 2-6 days after the salt
container is filled with salt.
NOTE:
1. The salt container must be refilled when the salt warning light in
the control panel comes on. Though the salt container may be
full, the light indicator may not be off until the salt fully dissolves.
If there is no salt warning light in the control panel, use your best
judgement as to when load the salt into the softener dispenser
given the number of cycles the dishwasher has run.
2. If the salt overspills, a programme can be run to eliminate them.
C. Fill the rinse aid dispenser
Rinse Aid feature
The rinse aid is automatically added during the last rinse, ensuring a
thorough rinsing, spot and streak free drying.
Attention!
Only use branded rinse aid for dishwasher. Never fill the rinse aid
dispenser with any other substances (e.g. dishwasher cleaning
agent, liquid detergent), as this would damage the appliance.
18
dishwasher
When to Refill the Rinse Aid Dispenser
If there is no rinse aid warning light on the control panel, you can
estimate the amount of rinse aid to be added by the colour of the
optical level indicator "D" located next to the cap. When the rinse aid
container is full, the whole indicator will be dark . As the rinse aid is
lower, the size of the dark dot decreases. You should never let the
rinse aid get below ¼ full.
As the rinse aid diminishes, the size of the black dot on the rinse aid
level indicator changes, as illustrated below.
Full
¾ full
½ full
¼ full - Should refill to eliminate spotting
Empty
RINSE AID DISPENSER
1 To open the dispenser, turn the cap to the "open" (left) arrow and
lift it out.
2 Pour the rinse aid into the dispenser, being careful not to overfill it.
3 Replace the cap by inserting it aligned with the "open" arrow and
turning it to the "closed" (right) arrow.
The rinse aid is released during the final rinse to prevent water from
forming droplets on your dishes that can leave spots and streaks. It
also improves drying by allowing water to sheet off the dishes.
Your dishwashers are designed to use liquid rinse aids. The rinse aid
dispenser is located inside the door next to the detergent dispenser.
To fill the dispenser, open the cap and pour the rinse aid into the
dispenser until the level indicator turns completely black. The volume
of the rinse aid container is about 140 ml. Be careful not to overfill
the dispenser, as it could cause excess suds. Wipe away any spills
with a damp cloth. Don't forget to replace the cap before you close
the dishwasher door.
EN
KDW4752N
19