Before Connection; Risk Of Electric Shock; Mains Connection - Silvercrest SMK 41 A2 Instrucciones De Uso

 The appliance is not designed to be an integrated appliance.
 To ensure adequate ventilation, a minimum clearance of 30 cm to
the top and 5 cm to the back must be observed.
 Do not install near heat sources such as hobs, radiators, underfloor
heating etc. If installation near a heat source cannot be avoided,
use an appropriate insulation panel or maintain the following
minimum clearances to the heat source:
− To electric or gas ovens or similar: approx. 3 cm
− To oil or coal-fired ovens: approx. 30 cm
− If installed next to another cooling appliance, a distance to the
side of 10 cm is required.

3.3.2. Before connection

DANGER!

Risk of electric shock!

There is a risk of electric shock due to live parts.
 After installing the appliance, check that the mains connection
cable is not squashed or damaged.
 Do not operate the appliance if it has been visibly damaged or the
mains cable or plug is defective.
 In the event of damage, contact our Service Centre.

3.3.3. Mains connection

 Connect the appliance to a properly installed safety socket which
is easily accessible and close to the place of installation. The local
mains voltage must correspond to the technical specifications for
the appliance.
 The power socket must be easily accessible so that you can unplug
the appliance from the mains quickly if necessary.
 WARNING! Ensure the mains cable is out of harm's way and will
not trip people up. Do not use an extension cable.
 WARNING! Do not allow the mains cable to become trapped or
damaged during installation.
English -45