Working With The Device; Cleaning And Maintenance - MSW Motor Technics MSW-DA-17 Manual De Instrucciones

3.2. Working with the device

1. Unscrew the housing screws.
2. Remove the top of the housing and guide the welding machine cable through
the gun: one end of the cable should be led to the trigger and the other to the
handle through the head.
3. Secure the handle by tightening the screws.
4. Screw on the housing.
5. Clean the dent area.
6. When the welding machine is switched on, put the product to the dents and pull
them out by pressing the trigger.

3.3. Cleaning and maintenance

a) Store the device in a dry and cool place protected from moisture and direct
sunlight.
b) Do not spray the device with a stream of water and do not immerse it in water.
c) Regularly inspect the device for technical failure and damage.
d) Use a soft, damp cloth for cleaning.