Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
4. Use the flat end of the rod to fit the new tire (3.3).
3.3. Cleaning and maintenance
a)
After each cleaning, all components should be well dried before the device s
used again.
b)
Store the device in a dry and cool place protected from moisture and direct
sunlight.
c)
Do not spray the device with a stream of water and do not immerse it in water.
d)
Regularly inspect the device for technical failure and damage.
e)
Do not use sharp and/or metal objects for cleaning (e.g. a wire brush or metal
scraper) as these may damage the surface of the device.
f)
Moving parts must be lubricated regularly depending on how often they are
used.
g)
Regularly check the connections of all parts and tighten loose screws.
Publicidad
Tabla de contenido
