Tyrolit HCE150 Instrucciones De Funcionamiento Originales página 22

22
9 Pre-selection of the Cutting Depth
Fig. 2
10 Changing the Diamond Cutting Discs
The Cutting discs, spacer discs and the flange nut might heat up enormously during operation. You could burn your
hands or get cut or ripped by the segments. Therefore, always use protective gloves when changing the grinding
wheel. Before any work on the tool, disconnect the plug from the mains!
Attention!
Disconnect the power plug before carrying out any work on the device!
Fig. 3
Fig. 4
en
Set the desired cutting depth on the scale by turning the guard and
set the cutting depth on the scale then close the quick-release lever.
The quick-release lever must always be firmly closed when working.
Press the spindle lock button to lock the work spindle.
Actuate the spindle lock button only when the work spindle is at a standstill.
Otherwise, the machine may become damaged.
Open the clamping screw with the face spanner and remove the diamond cutting discs
as well as the spacer discs from the work spindle.
Clean the work spindle and all parts to be mounted.
Pre-selection of the Groove Width:
The groove width results from the number and thickness of the spacer discs between the two
diamond cutting discs and the cutting width of the diamond cutting discs.
The grove width is calculated as follows: groove width = Thickness of the spacer discs + width
of the diamond cutting discs.
Thickness of the spacer discs: 2, 3, 4, 5, 10 and 17 mm.
HCE150