Tabla de contenido
Publicidad
SET UP (for use with remote control or sensor)
This procedure lets you programme compatible controllers or sensors (transmitters).
PROCEDURE:
STEP 1
Press button 1.
The LED turns on.
STEP 2
Within 60 seconds press/touch the ON or other related button shortly on
your controller or sensor. A green light will flash once on your
transmitter.
The red LED light on the module will flash 3 times. Now press/touch the
button on the controller or sensor again shortly. The controller or sensor
is connected.
Note: the button on your controller or sensor to program the module is
either the ON or other main button.
CONNECT WITH CONTROLLER OR SENSOR
NOTE: It is advisable to program a maximum of 6 control units (modules) per single controller or sensor.
MEC MODULE SMART 1
PRESS BUTTON 1 SHORTLY
LED TURNS ON
1
A
B
RED LED LIGHT FLASHES 3 TIMES
1
A
B
EN
4
Publicidad
Tabla de contenido
