Troubleshooting - Electrolux ES11S Manual De Instrucciones

27 electrolux troubleshooting

Troubleshooting

Certain problems are due to lack of simple maintenance or oversights, which
can be solved easily without calling the service technicians, before contacting
the service center please carry out the check listed below.
Problem Possible cause(s)
a) Electric plug out of the socket.
b) Bonded in different voltage.
Does not work
c) Lack of electric power or fuse
blown.
d) Make sure cold water switch in
the rear side of dispenser is ON.
e) Voltage drop.
a) Electric plug out of the socket.
Water not cold
from cold tank
b) After setup, it will take up to 1
hour to chill the water until
minimal set temperature.
c) Make sure cold water switch in
the rear side of dispenser is ON.
a) Electric plug out of the socket.
Water not hot
from hot tank
b) After setup, it will take up to 15-
20 min to heat the water until
maximal set temperature.
c) Make sure hot water switch in the
rear side of dispenser is ON.
Excessive a) The appliance very close to a wall.
heating around
b) Ventilation vents obstructed.
dispenser
body
Noise a) Product leaning on the wall.
b) Uneven placement.
a) A hole or a crack in the bottle.
Water leakage
b) Overflow in the water collector.
c) Drainage cap not well tightened.
Solution
a) Plug in.
b) Connect in correct voltage.
c) Wait for electric power ON or
change fuse.
d) Push the switches to the ON
position.
e) Use a voltage stabilizer.
a) Plug in.
b) Wait one hour for the cold water
supply.
c) Push the cold water switch
(green) to the ON position.
a) Plug in.
b) Wait 15-20 min. for the heat water
supply.
c) Push the hot water switch (red) to
the ON position.
a) The appliance must be at least 25
cm from the wall.
b) Clear the ventilation vents.
a) The appliance must be at least 25
cm from the wall.
b) Even the appliance.
a) Replace the water bottle.
b) Empty the water collector.
c) Tighten the cap.
Problem Possible cause(s)
Steam coming a) Excessive heating inside the
out of hot water tank.
dispenser
Unpleasant a) Cleaning is made with non
taste of water recommended material.
b) Poor-quality water.
c) Water bottle shoddy.
troubleshooting electrolux 28
Solution
a) Disconnect the main power
source and call service centre.
a) Follow cleaning/sterilization
procedure correctly.
b) Make sure that the mineral water
supplier is of good quality.
c) Replace the water bottle.