Part Description - Carromco LUGANO 200 Instrucciones De Montaje

78153
PARTS IDENTIFIER
ASSEMBLING YOUR SCOOTER
IMPORTANT: Remove the scooter from the carton, read the assembly instructions in this manual before assembling
your scooter. The instructions are in a step-by-step sequence. Save all packaging and material until assembly has
been completed.
FOLDING MECHANISM
The front wheel and handlebar assembly is hinged at the front of the deck. To open the scooter into its riding position,
simply press the red button and lift the handlebar column up. When the handlebars and front wheel assembly are in
the correct riding position, the folding mechanism will snap and lock. To fold the scooter flat, press the button again
and move the column downwards, until the locking mechanism snaps.
GETTING THE SCOOTER READY TO ROLL
There is a risk of being crushed. Unfold the scooter with care. Pay particular attention to your fingers. The scooter is
delivered folded. To get it ready to roll, you have to unfold it.
1. Position the scooter with the rear wheel on the ground and the deck parallel to the ground.
2. Push in the folding mechanism button and pull the handlebar column upwards until it clicks into place. The button
will automatically pop out again.
NO.

PART DESCRIPTION

1 FOLDABLE HANDLEBARS
2 HANDLEBAR COLUMN
3 QUICK RELEASE CLAMP
4 SAFETY DEVICE FOR HANDLEBARS
5 FOLDING MECHANISM
6 DECK
7 FOOT BREAK
8 KICKSTAND
9 FRONT WHEEL
10 HANDBRAKE
11 REAR WHEEL
-2-
ENGLISH
QTY
2
1
1
2
1
1
1
1
1
1
1