HAMPTON BAY 93400 Guía De Uso Y Mantenimiento

PACKAGE CONTENTS
A
A - Lamp body x 1
Assembly and Installation
1
Attaching and installing the light
WARNING: Risk of electric shock. Do not install the light
within 10 ft. (3.05 m) of a pool, spa or fountain.
NOTE: Never push the fixture into the ground by the lamp
body. Do not use a hammer. If the ground is hard, use water to
soften it or a trowel to loosen the soil.
□ Insert the fixture wire on the wire connector (C) into the groove located on
the top of the ground stake (B).
□ Attach the lamp body (A) onto the top of the ground stake (B). Ensure the
fixture wire on the wire connector (C) stays centered on the groove of the
ground stake (B) to avoid damage to the fixture wire.
□ Prepare a hole where installation will be located. Make sure hole is not
larger than the stake (B).
□ Install the fixture in the ground by pushing on the foot step (1) on the
stake (B). Do not push down on the lamp body (A).
□ Rotate the knob on the side of the lamp body (A) to adjust your light up or
down.
□ Choose your desired Correlated Color Temperature (CCT) by rotating the
knob behind the lamp body (aa) clockwise or counter-clockwise to choose
one of the three options available; 2700K warm white, 3000K warmest
white, or 4000K bright white.
aa
Use and Care Guide
LED CCT Low Voltage Spot Light
aa
1
B
B
B - Stake with foot step x 1
2
Connecting the wires
□ Detach and place the wire connector (C) on opposite sides of the low
voltage cable (not included) where the fixture will be located.
□ Align and fit the main low voltage cable vertically in the slot of the wire
connector as shown.
□ Press the wire connector (C) together until it is fully seated and locked
around the cable. Pre-set prongs will pierce the cable insulation and
establish contact. Turn on the power unit. If the light fixture does not
turn on, repeat operations 2 and 3.
□ Once the clip-on connector is in place, we recommend wrapping it in
electrical tape (not included) for additional protection.
C
A
C
C - Connector with 12 in. wire length
(attached to fixture) x 1
WARNING: The wire connector contacts (C) have sharp
edges for piercing the main low voltage cable. To avoid
injury, do not touch the metal contacts.
CAUTION: The wire from the low voltage power unit shall
be 12-16 AWG type underground Low Energy Circuit
Cable.
IMPORTANT: Protect the wiring by routing it in close
proximity to the light or next to a building structure such as
a house or deck.
Do not bury the wiring by more than 6 in. (15.24 cm) in
order to connect to the main secondary wire.
Do not submerge fixtures in water.
Please contact 1-855-HD-HAMPTON for further assistance.
Item #1006 619 199
Model #93400
C
HAMPTONBAY.COM