Hessaire EC14 Manual De Usuario página 2

Installation Steps
Step 1) Locate and cut square hole in interior ceiling between ceiling joists. Drill a small
pilot hole in each of the four corners going through to the attic. Draw a line between
holes and cut opening.
Step 2) Install junction box in desired wall location and install provided speed control in
junction box(single gang junction box sold separately). Follow wiring diagram below.
Step 3) Place fan housing in opening—guiding wiring up through access hole in switch
corner of housing. Fasten fan in place with 4 #10 screws. Connect wiring.
Step 4) Snap protective cover in place using spring clips in upper and lower fan housing
slots. Place decorative cap over switch corner of grill.
Step 5) From attic, slide shutter down over fan housing so louvers open up into attic.
Fasten in place with 4 #10 screws.
Step 6) Place insulation barrier(flange down) over shutter face frame so louvers can
operate with no obstructions. Fasten in place with 4 #10 screws.
Ceiling Joist
Wiring Diagram
(Black)
AC 120V / 60Hz
L
WARNING:
Electrical connections must be
done by qualified personnel in
N
accordance with all applicable
electrical codes. Unit must be
(Yel/Green)
properly grounded.
G
EC14 Manual Online 031622
Attic Side Steps
Install Insulation Barrier—Flange Down.
6
Ensure Louvers Are Not Obstructed.
5
Install Shutter Through Opening—
Over Fan Housing
Ceiling Opening
Red
AC
Control
Fan
(White)
White Common
Yellow/Green Ground
3
Turn speed control knob clockwise to increase speed of fan.
Turn counter-clockwise to decrease fan speed.
Turn speed control knob fully counter-clockwise to shut unit off completely.
If fan is not in use for extended period of time, "snap" on winter cover to help keep cool
air from entering interior space.
Ref. # Replacement Part Description
1
2
3
4
5 Speed Control Cap Cover
6
7
8
9 Variable Speed Controller
10
11
Problem
Black
Fan will not turn on
Black
Motor
Fan runs slow
Operation
Parts Illustration
Part #
Motor E050-4E
Propeller 6001308
Note: Please contact the distributor
Front Grill E14FG
where you purchased the fan with
Speed Control Knob E14K
any questions regarding the fan or
E14CC
if you are in need of replacement
Winter Grill Cover E14WG
parts.
Fan Housing E14FH
Weather Shutter E14WS
VSC14
Wall Switch Plate E14SP
Insulation Barrier EC14B
Troubleshooting
Cause / Remedy
Ensure unit is plugged in and switched on.
Receptacle breaker may need to be reset.
Make sure nothing is obstructing fan blade.
Fan motor may need to be replaced.
Control switch may need to be replaced.
Fan Intake or discharge shutters are obstructed
May need to replace capacitor
4
Visit www.hessaire.com
for warranty information
Hessaire.com