Aqua Medic DC Runner 400 Manual De Instrucciones página 6

Fig. 2: DC Runner 800/1000
1. Rubber feet
2. Bottom plate
3. Pump motor
4. Rear bearing
5. Impeller rotor
Available spare parts: Please refer to www.aqua-medic.de.
Safety advices
The pump is constructed for indoor aquarium use only. Before working on the aquarium, the power
6. EcoDrift Control
plug must be disconnected from the mains. The connection cable and the power plug must not be
changed. If the power cable is damaged, the pump must be scrapped.
5. Maintenance / Cleaning
From time to time, the pump needs to be cleaned. For cleaning, do the following: First of all, remove the bottom
plate. Then, turn the basket and take it off the pump. Now, the complete impeller can be taken out. It can be
cleaned under running water and then be re-assembled. When assembling, make sure that the ceramic shaft of
the impeller goes into the socket of the respective bearing.
6. Failures
The pump is designed to have a low maintenance requirement and under normal conditions will be very reliable,
provided it is protected from contamination. If the pump gets noisy, the suction basket and propeller need to be
cleaned or the impeller and bearings need to be replaced.
7. Warranty conditions
AB Aqua Medic GmbH grants the first-time user a 24-month guarantee from the date of purchase on all material
and manufacturing defects of the device. Incidentally, the consumer has legal rights; these are not limited by
this warranty. This warranty does not cover user serviceable parts, due to normal wear & tear. The original invoice
or receipt is required as proof of purchase. During the warranty period, we will repair the product for free by
installing new or renewed parts. This warranty only covers material and processing faults that occur when used
as intended. It does not apply to damage caused by transport, improper handling, incorrect installation,
negligence, interference or repairs made by unauthorized persons. In case of a fault with the unit during or
after the warranty period, please contact your dealer. All further steps are clarified between the
dealer and AB Aqua Medic. All complaints and returns that are not sent to us via specialist dealers
cannot be processed. AB Aqua Medic is not liable for consequential damages resulting from the use of any of
our products.
AB Aqua Medic GmbH - Gewerbepark 24 - 49143 Bissendorf/Germany
6. Front bearing
7. Housing's sealing
8. Pump lock
9. Filter basket
10. Connections
- Technical changes reserved – 07/2022/v1
6