Retrofit Installation - CREE LIGHTING CDR Serie Instrucciones De Instalación

TO INSTALL:
1
4

RETROFIT INSTALLATION

STEP 1:
Make sure the POWER is TURNED OFF in
which you are installing the product;
STEP 2:
Choose CCT & lumens that you want by dip
switch. See Figure 1.
STEP 3:
If existing lamp and trim are present, remove
from ceiling or move it out of the way as it will
not be needed during installation. See Figure
2.
STEP 4:
Measure the ceiling opening to make sure
the edge of the luminaire will cover the entire
hole and still sit firmly in the ceiling before
proceeding. For minimum and maximum
ceiling opening dimensions refernce Table 1
on the first page.
STEP 5:
Attach the carabiner safety clip to the existing
fixture housing. See Figure 3.
2 of 5
2
5
STEP 6:
Insert conduit from lamp and emergency
driver (if present) into the junction box and
wire to the power source per the Electrical
Connections section. See Figure 4. If
emergency driver accessory is being used,
mount test switch/indicator light in ceiling in
close proximity to junction box. Connect quick
connector on end of cord from test switch/
indicator light to mating quick connector on
end of cord in junction box. Reattach junction
box cover when finished.
NOTE: Total lead length from junction box to
test switch/indicator light is approximately 14
inches.
STEP 7:
Squeeze the two housing clips so they are
in an upright position and insert lamp into
housing. See Figure 5.
STEP 8:
Once lamp is inside the housing, release the
housing clips and continue pushing lamp into
3
6
housing until securely fixed and flush with
ceiling. See Figure 6.
STEP 9:
Restore power at the source and the
installation is complete.
LPN00687X0001A1_A