Residual Risks - Battipav MIXIT Manual De Instrucciones

GB
attention must be paid to the addition of lime, cement or aggregates when nearing the end of the mixing process.
• When mixing is complete, turn off the MIXIT and disconnect it from the mains.
Epoxy resins
• For mixing epoxy resin, check the viscosity and the density of the products to be prepared, so that the
mixer motor is not overloaded.
• Pour into the drum the quantity of resin, hardener and any powders indicated by the products' supplier.
9
• Start the MIXIT at speed 2.
• Mix carefully to prevent bubbles or lumps forming in the mixture.
• When mixing is complete, switch off the MIXIT and disconnect from the mains
Paints (Proceed as in the previous paragraph)
• Pour the paint to be mixed into the mixer drum and add the necessary amount of water required for the solution.
• When mixing is complete, switch off the MIXIT and disconnect from the mains
THE USE OF CHEMICAL PRODUCTS OR SOLVENTS MAY AFFECT THE PROPERTIES OF THE BASKET, MADE
OF HIGH DENSITY POLYETHYLENE PET. CHECK THE COMPATIBILITY OF THE PRODUCTS TO BE MIXED WITH
THE PROPERTIES OF THE MACHINE BEFORE USE.

RESIDUAL RISKS

During the design phase, BATTIPAV SRL paid particular attention to the aspects that may generate risks for the safety and health
of operators. In spite of this, there are still some potential risks, which are described below:
Danger of presence of electric current.
The machine has an internal electric system. CONNECT THE MACHINE TO A SYSTEM WITH DIFFERENTIAL
PROTECTION AND EFFECTIVE EARTH WIRE.
Danger of prolonged exposure to noise.
The continuative use of the machine causes an exposure to noise levels above 85 dB (A).
OPERATORS MUST USE PROPER EAR DEFENDERS.
Danger of exposure to fragments of materials.
OPERATORS MUST WEAR PROTECTIVE GOGGLES.
ALWAYS STAY IN THE WORKING POSITION (Pos. 1 picture 10) DURING THE MACHINE OPERATION PHASES:
• During material loading;
• During mixing;
• During the tool deceleration following the machine stop.
MAINTENANCE
BEFORE PERFORMING ANY OPERATION OR ADJUSTMENT, DISCONNECT THE MACHINE FROM THE SUPPLY
MAINS.
CLEANING
DO NOT WASH THE MACHINE WITH HIGH PRESSURE WATER JETS
• Clean the mixing basket regularly to remove residues.
• Check the mixing tool and the basket for wear.
IN ORDER TO REPLACE THE LUBRICATING GREASE, CONTACT YOUR RETAILER.
16
Battipav srl