Important Safeguards - Forno FFFFD1974-31SB Manual De Instrucciones

Follow handling instructions carefully. Flammable refrigerant used.
Before the beverage cooler is used, it must be properly positioned and installed as described
in this manual, so read the manual carefully. To reduce the risk of fire, electrical shock or injury
when using the beverage cooler, follow basic precautions, including the following:
• Plug into a grounded 3-prong outlet, do not remove grounding prong, do not use an adapter, and do not use an
extension cord.
•Reinstall all panels before operating.
•It is recommended that a separate circuit, powering only your beverage cooler, be provided. Use receptacles that
cannot be turned off by a switch or pull chain.
•Never clean appliance parts with flammable fluids. These fumes can create a fire hazard or explosion.
Do not store or use gasoline or other flammable vapours and liquids in the vicinity of this or any other appliance.
The fumes can create a fire hazard or explosion.
•Before proceeding with cleaning and maintenance operations, make sure the unit's power cord is unplugged.
•Do not connect or disconnect the electric plug when your hands are wet.
•Unplug the appliance or disconnect the power before cleaning or servicing. Failure to do so can result in electrical
shock or death.
•Do not attempt to repair or replace any part of your appliance unless it is specifically recommended in this material.
All other servicing should be left to a qualified technician.
• Use two or more people to move and install the appliance. Failure to do so can result in an injury to the back or
other part of the body.
•To ensure proper ventilation for your appliance, the unit must be completely unobstructed. Choose a well-ventilated
area with temperatures above 55ºF (13ºC) and below 90ºF (32ºC). This unit must be installed in an area protected
from the elements, such as wind, rain, water spray or sunlight.
•The appliance should not be located next to ovens, grills or other sources of high heat.
•The appliance must be installed with all electrical, water and drain connections in accordance with state and local
codes. A standard electrical supply (115 VAC only, 60 Hz), properly grounded in accordance with the National
Electrical Code and local codes and ordinances is required.
•Do not kink or pinch the appliance's power supply cord.
•The fuse (or circuit breaker) size should be 15 amperes.
•It is important for the appliance to be leveled in order to work properly. You may need to make several adjustments
to level it.
•All installations must be in accordance with local plumbing code requirements.
•Make sure that the pipes are not pinched or kinked or damaged during installation.
•Check for leaks after connection.
•Never allow children to operate, play with or crawl inside the appliance
•Do not use solvent-based cleaning agents or abrasives on the interior surface. These cleaners may damage or
discolour the interior.
•Do not use this appliance for uses other than its intended purpose.

IMPORTANT SAFEGUARDS

5