Connecting The Led Fixture To The Mains; Precautions When Using The Led Fixture; Inspection, Maintenance And Repair; Storage And Disposal - Lumatek ZEUS 600W PRO 2.9 Manual De Instrucciones

Ocultar thumbs Ver también para ZEUS 600W PRO 2.9:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 11

6.8 Connecting the LED fixture to the mains

Warning! Make sure mains power is switched off.
Warning! Ensure the power supply cable is not coiled and does not touch any hot surfaces.
Warning! Connect the cables according to local rules, safety regulations and electrical code.
Warning! If not using an external lighting controller ensure external switching gear can cope with the inrush
current of the LED fixture. Always use a timer contactor suitable for switching a capacitive load. Never use
household timers to switch the LED fixture!
Warning! Do not connect or disconnect the LED fixture under load.
Ensure the LED driver power supply cable self-locking female connector is correctly aligned to the correspond-
ing male connector on driver and push together until click-locked. To disconnect; turn female connector
anti-clockwise to unlock and pull apart from driver. Connect mains power plug to switching gear/power
supply. Switch on mains power.

7. PRECAUTIONS WHEN USING THE LED FIXTURE

Warning! Always ensure at least one light bar is connected to the fixture before switching on. The Zeus Pro has
an intelligent LED driver which will increase or decrease power to match the amount of light bars connected to
the system.
Warning! Always wait 20 – 30 minutes for the LED light bars to cool down.

8. INSPECTION, MAINTENANCE AND REPAIR

Warning! Disconnect the LED fixture from mains before performing any maintenance or repairs.
Warning! Do not connect or disconnect the LED fixture under load.
Warning! Do not open or disassemble the LED fixture, it contains no serviceable parts inside. Opening the LED
fixture can be dangerous and will void the warranty.
Warning! Always wait 20 – 30 minutes for the LED light bars to cool down.
Caution! Do not clean the LED fixture with detergents, abrasives or other aggressive substances.
Regularly check the LED fixture for dust or dirt build up. Clean if necessary. Contamination may cause
overheating and decreased performance.
Clean the outside of the LED fixture using a dry or damp cloth.
Regularly check the cables of the LED fixture to ensure it is undamaged.
The LED driver features surge protection for safe operation and device protection. In the event of over or
under mains voltage fluctuations, open or short circuit and over safe driver temperature; the LED driver will
switch off automatically. The driver will operate again when the surge protection parameter values are
within safe use range again.
To reset the LED driver; switch off mains power supply and then switch on mains power supply.

9. STORAGE AND DISPOSAL

Store the LED fixture in a dry and clean environment, with an ambient temperature of -25ºC to 55ºC.
The product must not be discarded as unsorted municipal waste but must be collected separately for the
purpose of treatment, recovery and environmentally sound disposal.

10. WARRANTY

Lumatek Ltd warrants the mechanical and electronic components of their product to be free of defects in
material and workmanship if used under normal operating conditions for a period of five (5) years from the
original date of purchase. If the product shows any defects within this period and that defect is not due to user
error or improper use Lumatek Ltd shall, at its discretion, either replace or repair the product using suitable new
or reconditioned products or parts. In case Lumatek Ltd decides to replace the entire product, this limited
warranty shall apply to the replacement product for the remaining initial warranty period, i.e. five (5) years
from the date of purchase of the original product. For service; return the product to your shop with the original
sales receipt.
info@lumatek-lighting.com
www.lumatek-lighting.com

Publicidad

Tabla de contenido
loading

Productos relacionados para Lumatek ZEUS 600W PRO 2.9

Tabla de contenido