BM2 BIEMMEDUE THERMAL Manual Del Usuario página 19

12 Troubleshooting
The table below gives the most common problems which may arise
during normal use of the high pressure washer.
These problems are easy to resolve with operations classified as
routine maintenance If the problem is not present in the following
table or cannot be eliminated following the instructions here, contact
customer service.
PROBLEM CAUSE
The machine does Electrical power
not start up supply absent or
inadequate
Electrical
protection
tripped
Motor does not start Inadequate
but makes a noise voltage
The water No diesel oil is
temperature does supplied
not reach the
Dirty diesel filter
required level
photoresistor
dirty
Broken
thermostat
The heating pipe
coil is clogged
with calcareous
REMEDY
Check the
characteristics of the
power line
Contact customer
service
Check the
characteristics of the
power line
Fill the tank
Clean the diesel oil
filter
Clean the
photoresistor
Request the
intervention
Request the
intervention
: