Selecting The Audio And Video Settings; Selecting The Osd Menus - GE UltraView LCD 17 in Manual De Usuario

EN • 14
Note: It takes about 2 to 3 seconds to change mode. When the mode is changed, the
monitor shows a blue screen then enters signal input, or shows the message "No
Signal".

Selecting the audio and video settings

Selecting the OSD menus

Program the monitor using the onscreen display (OSD) menus and submenus.
To change a monitor parameter, do the following:
1. Press the Mode button to select your input signal.
2. Press the Menu button to obtain the OSD menus for that input signal.
3. Press the up Up/Contrast or down Down/Brightness button to scroll the OSD list
displayed.
4. Before the OSD disappears, press the Menu button again to accept the changes.
UltraView LCD 17 in./19 in. Monitor
Press the Up/Contrast button
on the front panel to adjust the
contrast level.
Press the Down/Brightness
button on the front panel to
adjust the brightness level.
Press the Plus/Minus button on
the front panel to adjust the
volume level.