TFA 43.2039.01 Instrucciones De Uso página 9

TFA_No. 43.2039_Anleitung
LED-headlamp
• The battery cannot and must not be replaced or
removed by you. There is a risk of explosion if
the battery is replaced incorrectly. If necessary, a
qualified person can obtain instructions on how
to dismantle the permanently installed battery
from info@tfa-dostmann.de, should this be nec-
essary for the purpose of repairing or recycling
the product.
CAUTION
• Unauthorised repairs, alterations or changes to
the product are prohibited.
• Do not expose the device to extreme tempera-
tures, vibrations or shocks.
• Clean the device with a soft damp cloth. Do not
use solvents or scouring agents.
5. Elements (Fig. 1)
A 1: COB light stripe
A 2: LED focus light
A 3: Motion sensor
A 4: Charging symbol
A 5: ON/OFF button
A 6: Motion sensor ON/OFF button
A 7: USB-C port
29.06.2022
– 16 –
17:33 Uhr Seite 9
LED-headlamp
6. Charging
• Pull off the rubber protection. Plug the supplied
USB-cable into the designated port on the device
and connect the unit to a suitable USB power
source.
• To fully charge, leave the device connected for
approximately 2.5 - 3 hours.
• The device cannot be operated during the charg-
ing process.
• The charging symbol lights up red when the bat-
tery is charging. Once the light has changed from
red to green, the battery is fully charged.
• Disconnect the device from the charging power
source.
• As soon as the headlamp is powered on, the
charging symbol turns red. The red charging
symbol flashes when the battery needs to be
charged.
• Please charge the device immediately to preserve
battery life.
• Recharge the battery every six months, even if
the product is not in use.
• After charging, be sure to reseal the charging
port with the rubber protection.
7. Getting started/Operation
• Before the first use, please charge it fully.
• Press the ON/OFF button.
– 17 –