Electrical Connection; Fitting The Machine Undercounter - Onwa LV 455 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

2.5 Electrical connection

WARNING: Your machine is set to
operate at 220-240 V. If the mains voltage
supply to your machine is 110 V, connect a
transformer of 110/220 V and 3000 W
between the electrical connection.
Connect the product to a
grounded outlet protected by a fuse
complying with the values in the
"Technical Specifications" table".
The earthed plug of the
machine must be connected
to an earthed outlet supplied by
suitable voltage and current.
In the absence of earthing
installation, an authorised
electrician should carry out an
earthing installation. In the case of use
without earthing installed, we will not be
responsible for any loss of use that may
occur.
The plug on this appliance may
incorporate 13A fuse depending on
the target country. (For Example UK,
Saudi Arabia)

2.6. Fitting the machine undercounter

If you wish to fit your machine undercounter,
there must be sufficient space to do so and
the wiring-plumbing must be suitable to do
so (1). If the space under the countertop is
suitable for fitting your machine, remove the
worktop as shown in the illustration (2).
WARNING: The countertop, of which
the machine will be placed under, must be
stable in order to prevent imbalance.
The top panel of the dishwasher must
be removed to fit the machine under the
countertop.
To remove the top panel, remove the screws
that hold it on, located at the rear of the
machine. Then, push the panel 1 cm from
the front towards the rear and lift it. Adjust
the machine feet according to the slope of
the floor (3).
Fit your machine by pushing it under the
counter taking care not to crush or bend the
hoses (4).
WARNING: After removing the top
panel of your dishwasher, the machine
should be placed in a space of the
dimensions shown in the figure below.
Product's Height
(±2 mm)
A: If there is no felt on the top of the
product; you should take into account this
product's height.
B1: If there is felt on the top of the product
with 2nd basket; you should take into
account this product's height.
B2: If there is felt on the top of the product
with 3rd basket; you should take into
account this product's height.
EN - 7
A
B
All
B
Products
1
820 mm
825 mm
835 mm
B
2

Publicidad

Tabla de contenido

Solución de problemas

loading

Productos relacionados para Onwa LV 455

Este manual también es adecuado para:

Lv 455i

Tabla de contenido