Venga VG RVC 3002 Manual De Instrucciones página 12

D. Charging the robot
Note: A new battery does not come with a full charge and must be entirely charged
before using the device for the first time. Please charge the robot at least 4 hours before
using it for the first time. Charge the battery at room temperature between 4 and 40°C.
Your Venga! robot vacuum cleaner can be charged in two ways:
• Place robot onto the charging station, make sure
the charging contact points on the charging
station match up with those underneath the
robot. The green LED light will start to blink slowly
as the robot is charging.
• Plug the power adaptor directly into the
machine and connect the other end to the
power supply.
Note: If you are using the charging station, pressing the ON / OFF button (
the charging while carrying out the cleaning work. However, this operation cannot be
performed when the power adapter is used for direct charging.
Note: When cleaning is complete or the battery charge is less than 20%, the robot will
automatically switch to charging mode and start searching for the charging station. The
signal width between the charging station and the robot is about 4 m. If the robot does
not receive the signal, it searches along the edges to find the charging station again.
E. Wi-Fi Connection
Note: The device only supports a 2.4 GHz Wi-Fi network.
Please follow the procedure in the separate Wi-Fi connection instructions placed on top
of the robot vacuum cleaner.
VG RVC 3002 12
) will pause