Remote Control - Swann Alpha Serie Manual De Instrucciones

OVERVIEW
Spotlight
LED Light
Auto (sensor) mode: 400 lumens
Manual mode: 200 lumens
Enforcer Red & Blue
TM
Flashing LED Lights
Light Sensor
The ambient light sensor prevents
the spotlight from automatically
activating during the daytime to
preserve battery life.

Remote Control

Override sensor and manually
turn LED Light ON for 10 minutes.
(after 10 minutes the LED Light
will turn off and operate in auto
The spotlight will switch back to
auto mode after 1 hour if no other
Set LED Light to stay OFF
when motion is detected
Set Enforcer Lights to stay OFF
when motion is detected
Set motion sensor sensitivity to
Low. Detection range is up to
Set motion sensor sensitivity
to Medium. Detection range is
Keeping the LED Light on continuously for prolonged periods
of time will significantly shorten battery lifespan and reduce
operating time.
EN
2
Knuckle Screw
mode)
Power OFF.
button is pressed
10ft/3m
up to 13ft/4m
Battery
Compartment
Passive Infrared
Motion Sensor
Mounting Base
Thumb Screw
Mounting Base
Infrared (IR) signal transmitter
Override sensor and manually
turn LED Light ON for an indefinite
amount of time until you press the
Power OFF button
Set LED Light to automatically turn
ON when motion is detected.
LED Light will turn off 20 seconds
after no motion is detected
Set Enforcer Lights to automatically
turn ON when motion is detected.
Enforcer Lights will turn off 20
seconds after no motion is detected
Set motion sensor sensitivity to
High. Detection range is up to
20ft/6m