Preparation - Harbor Breeze PL125BK Manual De Instrucciones

SAFETY INFORMATION
WARNING
• To avoid personal injury, the use of gloves may be necessary while handling fixture parts with sharp
edges.
• A fixture must always be mounted directly to a post (for a post light) or pier base which is first
installed according to the electrical specifications and instructions accompanying that product. Wire
connectors will not support the weight of a fixture. Suspending a fixture by the house wires and wire
connectors will result in the fixture falling, with the possibility of personal injury and the danger of
electrical shock or fire.
• To reduce the risk of fire, electrical shock or personal injury, wire connectors provided with this light
fixture are designed to accept only one 12-gauge house wire and two lead wires from the light
fixture. If your house wire is larger than 12-gauge or there is more than one house wire to connect to
the corresponding fixture lead wires, consult an electrician for the proper size wire connectors to
use.
• To reduce the risk of damage to the fixture, DO NOT use power tools to assemble any part of the
fixture.
• Failure to caulk fixture mounting surface with silicone weather sealant may result in water damage in
outlet box, which may cause electrical malfunction or electrical shock.
CAUTION
• TURN OFF ELECTRICITY at main fuse box (or circuit breaker box) before beginning installation by
removing the fuse (or switching the circuit breaker off).
• If you are not sure the lighting system has a grounding means, DO NOT attempt to install this
fixture. Contact a qualified, licensed electrician for information regarding the proper grounding
methods as required by the local electrical code in your area.
• All fixtures must be mounted to a post (for a post light) or pier base that has been installed according
to the manufacturer's instructions for that product.
• DO NOT use bulbs having a wattage greater than the maximum value stated on the fixture. The use
of bulbs with higher wattage than specified will increase temperatures and risk of fire.
• If a dimmer control switch is used with this fixture, obtain professional advice to determine the
correct type to use as well as the electrical rating required.
• To avoid water damage to fixture or possible electrical malfunction, install fixture at least 4 ft. above
the ground/floor.

PREPARATION

Before beginning assembly of product, make sure all parts are present. Compare parts with package
contents list and hardware contents list. If any part is missing or damaged, do not attempt to
assemble the product.
Estimated Assembly Time: 25 minutes
Tools Required for Assembly (not included): Flathead Screwdriver, Phillips Screwdriver, Wire
Strippers, Pliers, Wire Cutters, Safety Glasses, Stepladder, Electrical Tape, Silicone Weather Sealant
Helpful Tools (not included): A/C Tester Light, Do-It-Yourself Wiring Handbook, Soft Cloth
4