Enpuly W1 Plus Manual De Instrucciones página 5

• Keep the nozzle tip aligned between the teeth
• Keep your mouth opened slightly so that the water can flow out.
• Press " " button to start irrigating.(Fig. 6)
① Direct the water jet flow at a 90-degree angle to the teeth and gums.
② Direct the water jet slowly along the teeth.
③ Direct the water jet along the gum line with the nozzle tip at a
90 degree angle to the gum tissue.
④ Cleaning between the teeth and around any braces, crowns or
bridgework thoroughly.
Fig. 6
• Press the " " and then press the nozzle unlock button to
replace others nozzles when needed. (Fig.7)
• Once irrigating is completed, press the "
Mode introduction:
From top to bottom(Fig.5)
Strengthen Mode: Relatively high water pressure for deep cleaning.
Recommended for people who get used to use the water flosser
Standard Mode: Recommended for most daily cleaning, usually be
used to clean food scraps
Soft Mode: Gentle water pressure. Recommended for first-time
users or for cleaning sensitive gums
Pulse Mode: The water pressure periodically cycles from low to
high. Recommended for massaging the oral.
Note: Do not point the spray
head directly at the gums.
" key again to pause it.
5
Manual control mode: When the indicator stays in this mode, the
product will only work continuously when you hold down the start
button.
When you release the start button, the device will pause immediately-
especially if you feel uncomfortable.
Note: The above recommendations are just for common use. For
people with oral disease or periodontitis, please consult your
dentist before use.
4.3 After using the appliance (Fig.8)
• Open the cap of the water tank and dispose of the water in the tank.
• Turn on the device and press the "Start" button to make it work
for about 10 seconds to drain the remain water in the water pipe.
Then close the water tank cap.
• Wipe the device with a dry cloth.
Note:
Fig. 7
To prevent bacteria from propagating, make sure there is no
remaining water in side the unit. If you're not going to use this
appliance for a long time, be sure to wipe and dry the appliance as
soon as possible before storing it.
5. Specifications:
Model: W1 Plus
Battery: 2000mAh
Pulse frequency: 1400rpm
Noise: 65db
Working temperature: 0-50℃ (32-122 ℉ )
Input voltage: DC 5.0V 1.0A
Waterproof rating: IPX7
6
Fig. 8