General Guidelines - Tooland DT20008N Manual Del Usuario

• Clean and rinse the pressure sprayer thoroughly after each use
by spraying 1 to 2 litres of clear water. Do not dispose of your
clean-up water into the sewer system but spray onto the treated
crops.
• Lubricate the moving mechanic parts such as the suction tube
inside the pump with some petroleum jelly.
3.

General Guidelines

•
Refer to the Velleman
•
All modifications of the device are forbidden for safety reasons. Damage caused by user
modifications to the device is not covered by the warranty.
•
Only use the device for its intended purpose. Using the device in an unauthorised way will
void the warranty.
•
Damage caused by disregard of certain guidelines in this manual is not covered by the
warranty and the dealer will not accept responsibility for any ensuing defects or problems.
•
Nor Velleman Group nv nor its dealers can be held responsible for any damage
(extraordinary, incidental or indirect) – of any nature (financial, physical...) arising from the
possession, use or failure of this product.
•
Keep this manual for future reference.
4. Assembly
•
Fit the lance assembly to the sprayer by means of the flexible hose.
•
Remove the nut fitted to the lance.
•
Insert the hose through nut.
•
Push the hose fitting fully onto the lance connector.
•
Screw nut tightly onto lance.
•
Attach the other end of the hose to the container using the above method.
•
Ensure that the hose is fully pushed on and that the nut is screwed down tight.
•
Fit the carrying strap by threading the expandable ring through the hole in the lug moulded
into the container base.
•
Fit the other end of the strap through the slot in the top lug and thread through the metal
buckle and adjust length to suit.
V. 01 – 18/10/2021
DT20008N
®
Service and Quality Warranty on the last pages of this manual.
3 ©Velleman Group nv