Battery Installation And Charging - Nevir NVR-3370BBW Manual De Instrucciones

EN
1. BATTERY INSTALLATION
AND CHARGING
(1) If it's powered by AAA batteries,
please install as shown below:
First Use: Open the battery cover on the back
of scale and put out the insulating strip.
Change battery: Open the battery cover on the
back of scale, then install the batteries properly
according to the pictures shown below.
Note：After battery installation,please close
the battery cover. Please use corresponding
battery. Remove battery if it is not used for a
long time(more than three months).
(2) If the scale is with built-in rechargeable
battery
1. The scale should be fully charged when firstly
used or after long-time stored. Battery symbol
flashes during charging and displays constantly
when charging is finished. It takes about 2 hours
to finish.
2. Please use android 5V charger with current
equal to or smaller than 2A. DO NOT use
charger with voltage larger than 5V.
3. Suggest to charge every 3 months if the scale
is not used for a long time.
Remark:
Battery symbol is shown on LCD during charging.
For your safety, please do not use the scale during
charging. Only start weighing after charging is
finished and removing charger.
2. DOWNLOAD AND SET UP
THE APPLICATION
Search "MovingLife" in "App Store" or
"Google Play" to download the Application.
Or in another most convenient way by
scanning the QR code below.
MovingLife
Tips：App is keeping updating, so it may
differ from showed on manual. For the final
and accurate information, please check on App.
3. REGISTERING AND CONNECTING
Open App "MovingLife", connect the device
with App and submit your personal profile.
(Before connection, please make sure Bluetooth
is turned on and scale LCD is lighted up)
Note：Please make sure your setted personal
information is correct, in order to get accurate
measurements.
9 10
EN
App: MovingLife