Standard Accessories - Ingco PLM5002 Manual Del Usuario

△
WARNING: Some dust created by power drilling contains chemicals known to cause cancer
birth defects or other reproductive harm. Some examples of these chemicals are:
■lead from lead-based paints
■arsenics and chromium from chemically reacted lumbe
Your risk rom these exposures varies, depends on how often you do this type of work. To
reduce your exposure to these chemicaIs: work in a well ventilated area, and work with
approved safety equipment.

STANDARD ACCESSORIES

Straight guide: a set
Extension guide: a set
Transparent guard: a set
Wrench: a set
Template guide: a set
Base guide: a set
Be sure to check the accessories as it is subject to change by areas and models.
OPERATION
1) POWER SUPPLY
Power tool plugs must match the outlet. Do not use any adapter plugs with earthed power
tools, Check the power supply, operation power should be a little less than rated power says
on the name plate.
2) CHANGING OF MILLING CUTTER
△ WARNING: To reduce the risk of injury, always unplug the tool and make sure switch is
turned off before any assembly and assembly and adjustment.
△ WARNING: Do not screw the lock nut too tighten to result in a bad effect on the chuck
inner wall of spindle.
(1) Loosen the lock handle, discharge the transparent guard carefully.
△ WARNING: When selecting a milling cutter, use the right type for your job. For best
performance, always use sharp cutter
NOTE: The highest speed of milling cutter fit for this edge trimmer should not less than
33000rpm
(2) Push the spindle lock button to lock the spindle. And then insert the milling cutter
directly into collet.
(3) Firmly tighten the lock nut to secure the milling cutter in place by a wrench. And then
attach the transparent guard back
NOTE: Ensure the correct collet is installed for the milling cutter to be used. Always
choose to right size collet fit your milling cutter.
(4) To remove the milling cutter just operate the reverse steps.
△WARNING: Do not tighten the lock nut without a milling cutter in place or you may break
the center piece of the collet.
8|English