Using Your Wine Cooler - LES PETITS CHAMPS CAVC15 Manual De Usuario

15 bottiglie
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 94
Description of the product features
1) Control panel
o The control panel is located at the top of the appliance, it is very easy to set the temperature of the appliance and
see what temperature the appliance is set to.
2) Interior light
o The wine cooler has an interior light. The light can be switched on and off by using the light control button.
3) The wine cooler shelves
o The shelves are fully adjustable to suit various wine bottle shapes and sizes.
o To prevent damaging the door gasket, make sure the door is fully open when pulling shelves out of the rail
compartment.
o The shelves are placed in factory mode that result in the most efficient use of energy for the refrigerating
appliances.

Using Your Wine Cooler

Before switching on
Make sure that it has been installed by a suitably qualified person, as per the information contained in the
installation instructions.
After delivery, wait for four hours before connecting the appliance to your mains supply. This will allow any
refrigerant gasses that may have been disturbed during the transportation process to settle.
The outside of the appliance and the removable accessories contained within it, should be cleaned with a
solution of liquid detergent and water.
The interior of the appliance should be cleaned with a solution of sodium bicarbonate dissolved in lukewarm
water. The interior and accessories should be thoroughly dried, after the cleaning process has been completed.
There can be an odor when you first switch on the appliance. It will lessen as the appliance starts to cool.
During first use
IMPORTANT: When you use the wine cooler for the first time or restart the appliance after it has
been turned off for a long time, there could be a few degrees variance between the
temperature you select and the one indicated on the LED display. This is normal and it is due to
the length of activation time. Once the wine cooler has been running for a few hours everything
will be back to normal.
o When you first switch on the appliance, the compressor will run continuously until the wine cooler reaches a cool
enough temperature.
o During this period of time, you should try not to open the door frequently or place bottles inside of the appliance.
o If the unit is switched off or unplugged, you must allow at least 5 minutes before restarting the appliance or
reconnecting it to your mains supply.

Publicidad

Tabla de contenido
loading

Tabla de contenido