Cable Connection - Creality 3DPrintMill Manual Del Usuario

Cable Connection

5
Power cord x 1
14
14
After the display is installed, please
connect the display cable.
Connect the Y-axis limit line.
A
Insert the Teflon tube into the
pneumatic connector (also insert
the blue wire clamp)
Connect the broken detection line
as shown in Figure A .
Caution
●Select the correct input voltage match
(115/230V)
your local power.
●Damage can occur if voltage is set
incorrectly.
●Connect the power cord to turn the power
switch on.
Do not connect or disconnect the cables
when the machine is powered on.
30