Black and Decker MTRS10 Traducido De Las Instrucciones Originales página 6

ENGLISH
Have defective cords replaced immediately.
u
Do not expose the charger to water.
u
Do not open the charger.
u
Do not probe the charger.
$
u
The charger is intended for indoor use only.
+
Read the instruction manual before use.
Electrical safety
#
Your charger is double insulated; therefore no
earth wire is required. Always check that the
mains voltage corresponds to the voltage on the
rating plate. Never attempt to replace the charger
unit with a regular mains plug.
If the supply cord is damaged, it must be replaced by the
u
manufacturer or an authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Features
Tool shown is MT218. Other tools are available for use with
this tool head.
This tool includes some or all of the following features.
10. Recip saw head
11. Blade clamp
12. Blade clamp lever
13. Shoe
Assembly
Warning!
Before assembly, remove the battery from the tool
and make sure that the saw blade has stopped. Used saw
blades may be hot.
Fitting and removing the saw blade (fig. A)
Hold the tool away from the body
u
Pull the blade clamp lever (12) up to release the blade
u
clamping mechanism.
Insert the shank of the blade fully into the blade clamp
u
(11).
Push the blade clamp lever (12) down to lock the blade
u
clamping mechanism.
Note: The blade can be installed with the teeth up to assist
in flush cutting.
Removing the saw blade (fig. A)
Warning! Burn hazard: Do not touch the blade immediately
after use. Contact with the blade may result in personal injury.
Pull the blade clamp lever (12) up to release the blade
u
clamping mechanism.
Remove blade.
u
6
(Original instructions)
Use
Warning! Let the tool work at its own pace. Do not overload.
Warning! Never use the tool when the saw shoe is loose or
removed.
Switching on and off
Note: Ensure the forward reverse slider (2) is not in the
locked position..
To switch the tool on, press the variable speed switch (1).
u
The tool speed depends on how far you press the switch.
To switch the tool off, release the variable speed switch (1).
u
Sawing
Always hold the tool with both hands.
u
Let the blade run freely for a few seconds before starting
u
the cut.
Apply only a gentle pressure to the tool while performing
u
the cut.
If possible, work with the shoe (13) pressed against the
u
workpiece. This will improve tool control and reduce
tool vibration, as well as prevent the blade from being
damaged.
Hints for optimum use
General
Use a high speed for wood, a medium speed for
u
aluminium and PVC and a low speed for metals other than
aluminium.
Sawing wood
Clamp the workpiece securely and remove all nails and
u
metal objects.
Holding the tool with both hands, work with the shoe (13)
u
pressed against the workpiece.
Sawing metal
Be aware that sawing metal takes much more time than
sawing wood.
Use a saw blade suitable for sawing metal. Use a finetooth
u
saw blade for ferrous metals and a coarser saw
blade for non-ferrous metals.
When cutting thin sheet metal, clamp a piece of scrap
u
wood to the back surface of the workpiece and cut through
this sandwich.
Spread a film of oil along the intended line of cut.
u
Accessories
The performance of your tool depends on the accessory used.
BLACK+DECKER accessories are engineered to high quality
standards and designed to enhance the performance of your
tool. By using these accessories you will get the very best
from your tool.