Premier RR-4286USD Manual De Instrucciones página 6

WAKE TO BUZZER
Set the controls same with 'Wake to Radio' but Volume Control (6) to 'BUZZER' position. The buzzer can
then be switched off by pressing the Alarm Off Button (3) or it can be converted to the radio by selecting
switch (10) to 'ON' position.
WAKE TO MP3
Having inserted your SD Card or USB drive and set the volume at the desired level, proceed as follows:
1. Slide the ON/OFF/AUTO Switch (10) to 'AUTO' position.
2. Slide the AM/FM/USB Switch (8) to 'USB' position
3. Press the Alarm Set Button (3) and the Hour Button (1) together until the correct hour is displayed.
Press the Alarm Set Button (3) and the Minute Button (2) together until the correct minute is displayed.
The wake up time is now entered into the timer memory.
4 .To check the wake up time, simply press the Alarm Set Button (3) and the clock will show the preset
time. The preset wake up time will continue to be registered in the timer memory and the MP3 will
switch on by itself at the same time the next day.
5. To switch the MP3 off, simply press the Alarm Off Button (3).
SLEEP TO MUSIC
The radio can be set to switch off automatically for a length of time from 1 minute to 1 hour 59 minutes.
With all the controls preset in the 'Wake to Radio' or ' Wake to MP3' positions, press the Sleep Button
(4) and the Minute Button (2) together, to count down to the desired sleep time. To switch off the radio
before the preset sleep time period, simply press the Snooze Button (9).
SNOOZE CONTROL
The Snooze Button (9) allows the user an extra sleep time of about 9 minutes after the radio alarm is
switched on at the preset wake up time. When alarm sounds press Snooze Button (9). Alarm will turn off
and sound again in 9 minutes. This Snooze function can be used repeatedly.
BATTERY BACK-UP
Connect a 9 Volt battery to the terminals inside the battery compartment for the power back-up function.
If the AC power supply is interrupted (as during a storm), the battery supplies power to keep the time
and alarm setting in memory.
NOTE: The display will not be lit and the alarm will not sound until actual power is restored. The battery
only stores your settings in memory during a power failure.
GENERAL CARE
The cabinet can be cleaned with a slightly damp cloth. Make sure the AC cord is disconnected from the
outlet when cleaning.
Avoid leaving the clock radio in direct sunlight or in hot, humid, dusty places.
Keep the set away from heating appliances and appliances that generate noise, such as fluorescent
lamps or motors.
P-4
SPECIFICATIONS
Power source : 110V 60Hz / 220V 50Hz
DC back up : 9V (1!9V 6F22 not included)
Radio frequency : AM 530 - 1700KHz
: FM 88 - 108MHz
Output power : 0.36 Watt
P-5