Project E Beauty PE727 Manual Del Usuario página 10

Recommended Before Use
In order to determine if you have a Light Sensitivity Issue please follow
the instructions below. It is recommended that you test a small, less
sensitive area of skin (i.e., like your forearm).
Place the device on an area of the forearm.
1.
2. Switch ON the controller and allow the device to run for its full
10+minute treatment program. The device will automatically switch
o after 10 minutes.
3.
At any time if your skin feels any uncomfortable STOP using the
device immediately.
Wait 24 hours. You should NOT experience any adverse reaction
4.
during the next 24 hours.
A bad reaction to light occurs if you have pain or discomfort in the
treatment areas or any skin redness for more than two hours. It can be
due to medication, supplements, or a possible skin issue.
Eye Safety
The design of this mask does not cover the eye area. Therefore, it is
1.
not needed to put on eye protection while performing treatments.
Be sure you never look directly into the LEDs.
It is NOT recommended to shine the light source directly into eyes or
2.
the eyes of others.
Be sure you never look directly into the LEDs.
10
Light Sensitivity Test