Preparations At The Workplace; Inserting The Battery - Hilti NCT IS 045-A22 Manual De Instrucciones Original

max. cutting capacity for steel rope (standard) / guy wire (standard)
max. cutting capacity for steel rope (EHS) / guy wire (EHS)
max. cutting capacity for reinforcing bar
Storage temperature
Ambient temperature for operation
4.1 Battery
Battery operating voltage
Ambient temperature for operation
Storage temperature
Battery charging starting temperature
Weight (B22/2.6 (02))
Weight (B22/3.0 (01))
Weight (B22/4.0 (01))
Weight (B22/5.2 (01))
Weight (B22/8.0 (01))
5

Preparations at the workplace

WARNING
Risk of injury by inadvertent starting!
▶ Before inserting the battery, make sure that the product is switched off.
▶ Remove the battery before making any adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.1 Charging the battery
1. Before charging the battery, read the operating instructions for the charger.
2. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
3. Use an approved charger to charge the battery. → page 5
5.2

Inserting the battery

WARNING
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery and the contacts on the product
are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
6 English
15.9 mm
(5/8 in)
13 mm
(1/2 in)
13 mm
(1/2 in)
−20 ℃ ... 70 ℃
(−4 ℉ ... 158 ℉)
−17 ℃ ... 60 ℃
(1 ℉ ... 140 ℉)
21.6 V
−17 ℃ ... 60 ℃
(1 ℉ ... 140 ℉)
−20 ℃ ... 40 ℃
(−4 ℉ ... 104 ℉)
−10 ℃ ... 45 ℃
(14 ℉ ... 113 ℉)
0.5 kg
(1.1 lb)
0.6 kg
(1.3 lb)
0.7 kg
(1.5 lb)
0.8 kg
(1.8 lb)
1.1 kg
(2.4 lb)
2258525
*2258525*