PALSON Kompact Modo De Empleo página 14

GB
- To vacuum dust: empty the dust compartment, if it contains dust. Dry the compartment
and filter thoroughly.
- To vacuum liquids: empty the dust compartment if it contains liquids. Use the wet
nozzle (scraper for liquids) (9).
- Check the level by putting the appliance in a vertical position with the nozzle facing
towards the floor. Empty the dust compartment before it reaches the maximum level.
- Long tube: Join both parts and secure the long tube to the vacuum cleaner. Use the
long tube to reach areas that are hard to reach, for instance, air conditioning ducts.
(Fig. 8)
- The long tube support is attached to the pedestal by two screws at the bottom of the
support and the pedestal. (Fig. 9)
how to assembly the charger support
The vacuum cleaner comes with a support designed specially to hold the charger, so it
can be charged from a wall. (Fig. 1)
1. To assemble the support put it in the required position in the wall and mark the holes
for securing the support on the wall or mounting surface with a sharp pencil. Check
that the wall support is in vertical position.
2. Drill a hole on each mark. Insert a plastic plug into each hole.
3. Put the screw into the top plug, leaving the screw exposed.
4. Put the support on the exposed part of the screw and slide the support downwards
so that the screw fits into the groove.
5. Put the second screw in the plug at the bottom of the support and tighten to anchor
the support.
how to empty the vacuum cleaner
- Always turn off the vacuum cleaner before opening it.
- Press the release button and remove the dust compartment. (Fig. 2)
- Remove the dust compartment filters and empty the container. (Fig. 3, 4, 5)
- Eliminate the dirt and dust from the filter. Use a damp cloth to clean the inside of the
dust compartment.
- To clean the outside, wash with cold or lukewarm water.
- Remember. It is advisable to test the filters before putting them back in the dust
compartment.
- Check that the filter is in the correct position before using it again.
- To collect as much dust as possible, the filter must be clean and the dust compartment
empty.
14