Warm Audio WA-CX12 Manual De Instrucciones página 5

FEATURES
1. Contents
Your WA-CX12 package includes; the WA-CX12 microphone, power supply, IEC power cable, shock mount, 7 pin
Gotham cable, and premium tweed storage box.
2. Power Switch
The power switch is located on the power supply.
3. IEC Power Inlet
The IEC power inlet is located on the rear side of the power supply and allows for a standard IEC cable to connect
the power supply to your wall power outlet.
4. 115V/230v Voltage Selector Switch
A voltage selector switch is located near the IEC inlet on the power supply and allows for the user to set the appro-
priate voltage for the country they are located. We advise you to be careful with this switch because plugging in the
unit at the wrong voltage setting will likely damage the WA-CX12 and its power supply. Plugging in the WA-CX12
power supply at the incorrect voltage could even cause injury or death. Typically the voltage selector switch will be
pre-set to the proper voltage for the country where the product was purchased and should not be changed.
5. Polar Pattern Select Switch
The polar-pattern selection switch is located on the power supply and provides 9 pattern options. Patterns are:
Cardioid, Omni, and Figure-of eight, and 6 intermediate stages.
6. 7 pin microphone cable connector (female)
A 7 pin female microphone cable connector is located on the power supply. The 7 pin Gotham branded cable
included in the WA-CX12 box is connected to this connector on one end and to the WA-CX12 microphone on the
other.
7. 7 pin microphone cable connector (male)
A 7 pin male microphone cable connector is located at the base of the WA-CX12 microphone. This connection pairs
the WA-CX12 microphone to its power supply.
8. XLR Output
A standard 3 pin XLR male connector is located on the power supply. The microphone's signal will exit this connec-
tor. Connect this connector to a preamp via a standard 3 pin XLR microphone cable.
4