Technical Characteristics - Solter DEVIL Manual De Instrucciones

INTRODUCTION
We appreciate your deference to our brand and we hope the welding helmet you have just purchased will be of great
use to you. This instruction manual contains the necessary warnings for correct use within the maximum safety
conditions for the operator. SOLTER welding filters must be used by expert personnel who know and understand the
risks involved in using them. In case of misunderstanding or doubts about this manual, please contact us. Handling
the weld filter carries a significant risk of injury. Please refrain from doing any manipulation on the filter or helmet. Only
technically trained personnel can do it.
SOLTER Welding SL, declines all responsibility for negligent practices in use and / or handling. This manual should be
attached and kept with the filter model purchased. These filters are designed and approved in accordance with
European Standard EN 379.
It is the responsibility of the people who use and repair them that the product does not fail to meet the requirements of
the aforementioned standards.
BEFORE STARTING TO WELD
Before using any of the welding filters be sure to remove the corresponding protection films, keep the viewing area
and the front part of the filter clean since there are the sensors that take care of the filter darkening.
Inspect all operating parts before using the display and check for signs of deterioration. Any damaged part must be
replaced immediately before use. Check the operation of the filter before each use.
Also make sure that the attachment to the protection screen is correct to prevent it from detaching in the event of any
impact, which could cause personal injury to the user.
If the filter darkening DIN is adjustable, adjust it correctly before any application. To find out the appropriate degree for
all applications, consult the section FILTER CHOICE CHART ACCORDING TO APPLICATION of the protection
screen manual.

TECHNICAL CHARACTERISTICS

PROPERTIES
Viewing area
Front
Optical class
sensors
Dimming variable
Darkening range
Grinding mode
Sensitivity Variable
Reaction time (light>
dark)
Switching time (dark>
light)
UV / IR protection
Type of energy
Weight
CE marking
All filters are marked as indicated by the CE certificate of each model. In this marking, the first number specifies the
degree of DIN protection that the filter has when it is in the open state (clear), the next number indicates the DIN
degree in the closed state (dark) indicating the minimum and maximum degree. The symbol between the two numbers
tells us if the DIN degree setting is manual or automatic. The next three numbers indicate the type of optics, the filter's
DEVIL / GUARDIAN / WELDER / JOB / ARMY /
STEAMPUNK / R-10
100 x 60 mm
polycarbonate 115 x 104 mm
Solar panel and replaceable battery CR2450 / CR2032 for R-20
0,57 Kg.
1/1/1/1 Arc
4
Yes (External)
DIN 5-8 / 9-13 (External)
DIN 4 (External)
Yes (External)
1/30000 s
0.1 - 1.0 s
DIN 16
0,53 Kg.
R-20 DI R-10XL
100 x 53 mm 100 x 100 mm
117 x 136 mm
0,66 Kg.
8