G-Systems GSE ED61-210EU Manual Del Usuario página 13

Manual GSE-Humidifier-Dehumidifier controller
Thank you for purchasing the GSE-Humidifier-Dehumidifier
controller. The GSE-Humidifier-Dehumidifier controller is a
humidity controller to command Foggers- humidifier's or air-
conditioning-dehumidifier. The function involves maintaining a
room at constant humidity.
EN
The warranty is only valid with a warranty card containing
sales date and stamp from the place of purchase or electronic
registered warranty at https://g-systems.eu/warranty-check. If
this is not so, please return immediately to the sales office!
1. Power ON LED
2. Humidity LED
3. Regulation knobs
4. Socket 1 (humidifier or dehumidifier)
5. Wall mounting bracket
6. Cable gland 12mm (sensor)
7. Cable gland 16mm (power cable)
Before installing the controller, expose the wall-mount
brackets. Use the screws supplied with the controller when
mounting the controller to your wall.
Install the humidity sensor which is provided with a 4 m long
cable at a point where you wish to undertake the measurement.
Ensure that this is not directly exposed to a heat source or stream
of light in order to obtain the most precise measurement of the
ambient air. A small voltage in the sensor cable is thus harmless
for the surroundings. Don't let the sensor fall, hit or get in contact
with water or aerosol!
Now insert the power plug into the socket. The controller
initializes itself, this can last up to 10 seconds and the green On
10
light flashes.
Foreword
Warranty
Legend
Mounting Installation
Instructions