Ec Declaration Of Conformity - Powersoft T Serie Guia Del Usuario

Regulatory Compliance Statements
The Manufacturer:
Europe
Powerso� S.p.A.
If the time arises to dispose of your product, please recycle all possible component.
Via E. Con�, 5
This symbol indicates that when the end-user wishes to discard this product,
it must be sent to separate collection facilities for recovery and recycling.
50018 Scandicci (FI), ITALY
By separating this product from other household-type waste, the volume of
waste sent to incinerators or land-fills will be reduced and natural resources
will thus be conserved.
The Waste Electrical and Electronic Equipment Directive (WEEE Directive) aims to
Declare that under our sole responsibility the products that:
minimise the impact of electrical and electronic goods on the environment. Powersoft
S.p.A. comply with the Directive 2012/19/EU of the European Parliament on waste
Model:
electrical finance the cost of treatment and recovery of electronic equipment (WEEE)
in order to reduce the amount of WEEE that is being disposed of in land-fill site.
All of our products are marked with the WEEE symbol; this indicates that this product
must NOT be disposed of with other waste. Instead it is the user's responsibility to
dispose of their waste electrical and electronic equipment by handing it over to an
approved reprocessor, or by returning it to Powersoft S.p.A. for reprocessing. For
more information about where you can send your waste equipment for recycling,
Intended use:
please contact Powersoft S.p.A. or one of your local distributors.
USA
Are in conformity with the provisions of the following EC Direc�ves, including all amendments, and with
FCC Supplier's Declaration of Conformity
Responsible Party:
na�onal legisla�on implemen�ng these direc�ves:
Powersoft S.p.A.
− 2014/35/EU
Via Enrico Conti, 5
50018 Scandicci (FI) – Italy
− 2014/30/EU
Phone: +39 055 735 0230
Fax: +39 055 735 6235
− 2011/65/EU
FCC Compliance Statement
This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions:
The following harmonized standards are applied:
1) This device may not cause harmful interference, and
2) this device must accept any interference received, including interference that may
EN 55032:2012,
−
cause undesired operation.
CAUTION: Changes or modifications not expressly approved by the party responsible
EN 55032:2012/AC:2013
−
for compliance could void the user's authority to operate the equipment.
− EN 55035:2017
NOTE: This equipment has been tested and found to comply with the limits for
a Class A digital device, pursuant to part 15 of the FCC Rules. This equipment
− EN 61000-3-2:2014
generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instruction manual, may cause harmful interference
− EN 61000-3-3:2013
to radio communications. However, there is no guarantee that interference will not
− EN 61000-3-11:2000
occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment
−
EN 62368-1:2014
off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
−
EN 62368-1:2014/AC:2015
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit
• Different from that to which the receiver is connected.
WARNING: This is a class A product. In a domestic environment this product may
Scandicci,
cause radio interference in which case the user may be required to take adequate
measures
27 August 2020
Canada
Canadian Caution
This device contains licence-exempt transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development Canada's licence-exempt RSS(s).
Operation is subject to the following two conditions:
1)This device may not cause interference.
2)This device must accept any interference, including interference that may cause
undesired operation of the device.
WARNING: This is a class A product. In a domestic environment this product may
cause radio interference in which case the user may be required to take adequate
measures
ICES-003 Class A Notice
This Class A digital apparatus complies with Canadian ICES-003.
Radiation Exposure Statement
This equipment complies with RSS-102 radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body.
DECLARATION OF CONFORMITY
MEZZO 604 A, MEZZO 604 AD
MEZZO 602 A, MEZZO 602 AD
MEZZO 324 A, MEZZO 324 AD
MEZZO 322 A, MEZZO 322 AD
Professional Audio Amplifier
Low Voltage Direc�ve
Electromagne�c Compa�bility Direc�ve
RoHs Direc�ve

EC Declaration Of Conformity

Manufacturer:
Powersoft S.p.A.
via E. Conti 5
50018 Scandicci (Fi)
Italy
We declare that under our sole responsibility the products:
Model Names: T152, T154,
T302, T304,
T602, T604,
T902, T904
Intended use: Professional Audio Amplifier
Are in conformity with the provisions of the following EC
Directives, including all amendments, and with national legislation
implementing these directives:
2014/35/EU Low Voltage Directive
2014/30/EU Electromagnetic Compatibility Directive
2011/65/EU RoHs Directive
The following harmonized standards are applied:
EN 55032:2015,
EN 55032:2015 /A11:2020
EN 55035:2017,
EN 55035:2017 /A11:2020
EN 61000-3-2:2014
EN 61000-3-3:2013
EN 61000-3-11:2000
EN 62368-1:2014
EN 62368-1:2014 /AC:2015
Scandicci,
January 2021
Quality & Process Manager
For compliance questions only: compliance@powersoft.it
EN
Marco Ca�
T Series | 3