VONROC CR504AC Traducción Del Manual Original página 10

EN
Air loss
• May be caused by a poor seal of a connection.
• Check all air connections by wetting them with
a soapy water solution (Never use the solution
nearby electric connections).
• When the tank is empty and being filled. The
user might hear a sisseling sound by the pres-
sure switch. This is normal and will stop before
the compressor reach a pressure of 1.5 bar.
• Check if the drain cock (11) is closed well.
The compressor will not start
If the compressor is difficult to start, check:
• Whether the voltage of the mains corresponds
to that on the specification plate.
• Whether electrical extension cables are being
used with a faulty core or length.
• Whether the operating environment is too cold
(below 5°C).
• Whether there is electricity supply (plug properly
connected, magneto-thermal fuses not broken).
The compressor does not shut off
If the compressor does not shut off when the maxi-
mum pressure has been reached, the safety valve of
the tank will be activated. It is necessary to contact
the nearest authorised Support Service for the repair.
ENVIRONMENT
Faulty and/or discarded electrical or
electronic apparatus have to be collected at
the appropriate recycling locations.
Only for EU countries
Do not dispose of power tools into domestic waste.
According to the European Guideline 2012/19/EU
for Waste Electrical and Electronic Equipment and its
implementation into national right, power tools that
are no longer usable must be collected separately
and disposed of in an environmentally friendly way.
WARRANTY
VONROC products are developed to the highest
quality standards and are guaranteed free of
defects in both materials and workmanship for the
period lawfully stipulated starting from the date of
original purchase. Should the product develop any
failure during this period due to defective material
and/or workmanship then contact VONROC directly.
10
The following circumstances are excluded from this
guarantee:
• Repairs and or alterations have been made
or attempted to the machine by unauthorized
service centers;
• Normal wear and tear;
• The tool has been abused, misused or
improperly maintained;
• Non-original spare parts have been used.
This constitutes the sole warranty made by compa-
ny either expressed or implied. There are no other
warranties expressed or implied which extend
beyond the face hereof, herein, including the im-
plied warranties of merchantability and fitness for
a particular purpose. In no event shall VONROC be
liable for any incidental or consequential damages.
The dealers remedies shall be limited to repair or
replacement of nonconforming units or parts.
The product and the user manual are subject to
change. Specifications can be changed without
further notice.
WWW.VONROC.COM