Blaupunkt 5WK820FF0R Instrucciones De Uso página 41

28°C, do not lower the temperature to below 7°C.
IMPORTANT: after unplugging, turning off the power or after a power failure, it is
imperative to wait 5 minutes before turning it on again.
Temperature alarm
Your appliance is equipped with a visual and audible temperature alarm. If the error codes HH and LL
appear on the control panel display, check that you are not in the following situations:
- The appliance door is not closed properly
- The appliance has been switched on within the last 24 hours, or you have added
a large quantity of bottles at one time. In this case it may take longer to reach the
required temperature. The initial ambient temperature or the number of bottles
installed in the appliance may have an impact on the internal temperature.
If this is not the case, switch off and unplug the appliance and contact the Service Department with the
code that was displayed.
Door alarm
If the door has been left open for more than 60s, the alarm will sound. Press key I once to stop the sound
alarm if the noise disturbs you.
Interior light
The interior light makes it easy to view your wines labels and enhances the display of your collection.
Touching and holding the
lights:
- Functional mode (default): the light will turn on only when the door is
open, this is the most economic mode
- Showcase mode: light will turn on/off only by short touching of light key J.
Dynamic climate / silent mode
Wine cellars are designed to preserve your wines in perfect conditions over long periods in
complete safety. However, no frost systems can cause noise, this is the reason why the silent mode
is the default factory setting. Thus, you can switch off the silent mode to switch to the ventilated cooling
mode by pressing the key "+" (C) for 5 seconds. The cellar will emit 5 sound signals to confirm the
passage in ventilated cooling mode. Conversely, to deactivate the ventilated cooling mode and return
to the default silent mode, press and hold the key "-" (B) for 5 seconds. The cabinet will emit 3 sound
signals to confirm the silent mode.
Modes
ECO DEMO MODE
Eco demo mode can be activated by presenting the appliance at exhibitions, shows or in
salesrooms. In eco demo mode, compressor and all fan motors are switched OFF. By pressing and
holding the "+" and "- " (C and B) and light (J) keys at the same time for at least 5 seconds, the indicator
light will flash five times to confirm the input and the unit will operate in eco demo mode. Eco demo
mode can be abandoned by repeating the above process, be noted that compressor and fan will
activate 5 minutes later (for compressor protection reason).
mark (J) 5 seconds toggles between two modes of operation for the internal
EN