General Power Tool Safety Warnings - Powerworks P24MT Manual Del Operario

EN
1 DESCRIPTION
1.1 PURPOSE
You may use this product for cutting and sanding purposes.
1.2 OVERVIEW
Figure 1-6
Quick-release lever
1
On/off button
2
LED light
3
2 GENERAL POWER TOOL
SAFETY WARNINGS
Read all safety warnings, instructions, illustrations and
specifications provided with this power tool. Failure to
follow all instructions listed below may result in electric
shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
The term "power tool" in the warnings refers to your mains-
operated (corded) power tool or battery-operated (cordless)
power tool.
3 INSTALLATION
3.1 UNPACK THE MACHINE
Make sure that you correctly assemble the machine before
use.
• If the parts have damage, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the service
center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with local
regulations.
3.2 INSTALL THE ACCESSORY
Figure 3-1 / 3-2 / 3-3
1. Pull the quick-release lever and turn it counterclockwise
to loose the clamping plate.
Clamping plate
4
Variable speed dial
5
Locating pins
6
WARNING
WARNING
WARNING
English
2. Install the accessory and place it firmly onto the locating
pins.
3. Turn the quick-release lever clockwise to fasten the
clamping plate and accessory.
4. Put the quick release lever down.
3.3 INSTALL THE BATTERY PACK
Figure 2
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the motor stops before
you install or remove the battery pack.
• Read, understand, and follow the instructions in the
battery and charger manual.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
3.4 REMOVE THE BATTERY PACK
Figure 2
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
4 OPERATION
Always wear eye protection.
Do not use any attachments or accessories not
recommended by the manufacturer of this product.
4.1 START THE MACHINE
Figure 4
1. Push the on/off button in the on position.
4.2 STOP THE MACHINE
1. Push the on/off button in the off position.
4.3 ADJUST THE VARIABLE SPEED
Figure 5
The machine can be set at 6-speed adjustment positions.The
"1" position indicates the lowest and the "6" position
indicates the highest speed. You can adjust different speed by
turning the speed dial.
4
WARNING
WARNING
WARNING