Uline H-9496 Manual De Instrucciones página 2

MOUNTING
1. Remove threaded collar from powered grommet by
turning collar counterclockwise. Pull cord through
collar to completely remove the collar.
2. Pass cord through grommet hole and insert the
powered grommet into grommet hole. (See Figure 1)
NOTE: Powered grommet is compatible with 2⁄"
grommet holes.
Figure 1
NOTE: If inserting the powered grommet results
in a tight fit, sandpaper can be used to remove
a small layer of wood from inside the grommet
hole for a better fit.
3. Place power cord through threaded collar.
(See Figure 2)
Figure 2
PAGE 2 OF 6
ASSEMBLY
4. Secure powered grommet in grommet hole using
threaded collar. Tighten by turning collar clockwise
until it reaches underside of tabletop and creates a
snug fit. (See Figures 3-4)
Figure 3
5. Plug power cord into standard 120 – 125V outlet.
NOTE: Do not plug in equipment that exceeds
the max 12 Amp rating.
1-800-295-5510
uline.com
Figure 4
1221 IH-9496