ready to assemble. To avoid causing damages to the thread, DO NOT over-tighten the nuts or bolts.
1. Unpack the unit and confirm that you have all the hardware and required parts. Assembly the unit on a
carpeted floor or the empty carton to avoid any scratch.
2. Remove 2 Mounting Boards (D) from the Table Top (A) by unscrewing the wood screws and flat washers,
using a Phillips screwdriver, as shown.
3. Remove the additional wood blocks attached at the corners of Table Top (A) by unscrewing the wood
screws. These are used for shipping purposes only. After removing them, please discard.
Assembly Instructions
DO NOT fully tighten the bolts or nuts initially until all the bolts or nuts are
D
A
4