Whalen WF36DVW Manual De Instrucciones página 2

ASSEMBLY INSTRUCTIONS
Step 1:
Mark wall for vanity placement and note the location of the
water supply lines and drain on the back panel of vanity.
Step 2:
Move vanity (B) into proper place against the wall.
Step 3:
Install faucet, drain and supply lines (none included) to
vanity top (A) according to the instructions supplied with
those items.
v
1
v
2
B
v
3
3
ASSEMBLY INSTRUCTIONS
Step 4:
In case of uneven floors, floor levelers are provided at the
bottom of the vanity. If necessary, adjust floor levelers by
hand to correct tilting and/or level doors.
Step 5:
To mount the backsplash (C) to the wall, apply a thin bead
of silicone compound (not included) to the unpolished
back side and bottom of the backsplash (C). Position
backsplash (C) as shown onto vanity top (A) and against
the wall. Clean any excess silicone compound before
allowing to dry.
Step 6:
If the door preassembled to vanity base (B) require
adjustment, follow the below options as needed:
A
To adjust door up or down, loosen screws (a), adjust door
and tighten screws.
To adjust door left and right, turn screw (b) in or out.
To adjust door in and out, loosen screw (c), adjust door
and retighten screw.
v
4
v
5
C
Silicone
UP
A
v
6
B
4