Automated Learning Process./Activating Code; Remote Control - Craftmade Wyatt Guia De Instalacion

10. Automated Learning Process./Activating Code.

CAUTION: The remote control can be programmed to

REMOTE CONTROL

(back)
multiple receivers or fans. If this is not desired, turn
wall switch off to any other programmable receiver or
fan.
Remove battery cover on back side of remote
control. Install one 12-volt battery (included).
battery
Restore electrical power. Turn power off again for
at least 5 seconds and then turn power back on.
Within 60 seconds of restoring the power, press and
SET
hold the fan SET button for 5 seconds or until light
blinks twice. Then replace the battery cover.
NOTE: Battery is not rechargeable. Remove
batteries with low or no charge and dispose of
properly.
battery
cover
CAUTION: "DO NOT DISPOSE OF BATTERIES IN FIRE,
BATTERIES MAY EXPLODE OR LEAK. " - When
disposing of household alkaline batteries, it is best
to check with your local and state recycling or
household hazardous waste coordinators
concerning the specifics of the program in your
I I I IV
area. You may also locate a recycling center by
V
I I
calling 1-800-8-BATTERY or 1-877-2-RECYCLE or
VI
I
visit www.epa.gov/epawaste/index.htm or
www.earth911.org for more information.
WARNING: Choking Hazard - Small parts. Keep
battery away from children.
WARNING: Non-rechargeable batteries are not to
be recharged; Do not mix different types of
REMOTE CONTROL
(front)
batteries such as alkaline, carbon-zinc, or
rechargeable batteries; Do not mix old and new
batteries; Batteries are to be inserted with the
correct polarity; Exhausted batteries are to be
removed from the product.
page 9