Pelonis HO-0280 Manual Del Usuario página 6

INSTRUCTIONS TO REMOTE CONTROLLER
BATTERIES INSTRUCTIONS (included)
1. Press down on the battery compartment cover
and slide it out.
2. Use 1 "CR2032" lithium battery (included)
3. Insert the batteries, making sure that the positive
terminals are facing the proper way.
4. Replace the cover.
BATTERY WARNING
1. Do not dispose of batteries in fire, batteries may
explode or leak.
2. Do not mix old and new batteries.
3. Do not mix alkaline, standard (carbon-zinc) or
rechargeable (nickel-cadmium) batteries.
4. Non-rechargeable batteries are not to be recharged.
5. Batteries are to be inserted with the correct polarity.
6. Exhausted batteries are to be removed from the product.
7. The batteries must be removed from the remote controller before it is scrapped
and that they are disposed of safely.
SAFTEY FEATURES
The heater is equipped with an over-heat device which cause the unit to stop
operating in the event that the internal temperature exceeds the normal operating
temperature.
If the heater shuts down,
1. Turn off and unplug the heater.
2. Wait for at least 10 minutes until the heater cools.
3. Plug the heater into the power outlet and then turn it on.
Note: This heater includes a safety tip-over protection feature which will shut the
heater off in case it is tipped over. If, at any time, the heater does tip over, please
put the heater back in the upright position (wheels on bottom, controls on top).
The heater will resume its normal operation.
ON/Standby key
Mode key
Temperature/Time increase
Temperature/Time decrease
Timer key
5