Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Operation Part. II
UPS User´s Manual
III. LCD Display cont.
UPS Mode
Battery Mode
Overload
in battery mode
NOTE: The backlight will be always on when any fault or warning occurs.
IV. Fault Code Table
Fault condition
Output
short circuited
Overload
Inverter
/Output failure.
Overcharge
Battery voltage
is too low.
LCD
In battery mode press
button
to mute
alarm and
will be
on.
When battery level is
low,
icon will flash.
icon will flash.
LCD
*If fault alarm occurs, please call for service immediately.
Description
Alarm will beep every 10 seconds and LCD
information will be displayed in the
following order when pressing button.
1. Estimated backup time
2. Output voltage
3. Output frequency
4. Input voltage
5. Input frequency
6. Output power in W
7. Output power in VA
Alarm will beep every second. This alarm
cannot be muted.
When overload occurs, alarm will beep
every 0.5 second.
Solutions
Disconnect short-circuited loads and
restart the UPS again.
Turn off the unit and remove unnecessary
loads. Then, restart the UPS again.
Call for service immediately.
1. Turn off the unit and wait for cooling.
2. Or remove excessive loads and wait for
cooling.
Call for service immediately.
19 / EN
Publicidad
Tabla de contenido
